FC-202P4K0T4131X4502 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danfoss FC-202P4K0T4131X4502 is part of the VLT FC 202 AQUA Drives series and features a power rating of 4.0 kW and a horse power of 5.0 HP. Designed for three-phase 380 to 480 VAC operation, the drive has a continuous output current of 10 A at 380-440 V with an efficiency of 0.97. The unit allows for a maximum shielded motor cable length of 150 meters and supports operating ambient temperatures up to 50 degrees Celsius.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P4K0T4131X4502 is a variable frequency drive manufactured by Danfoss for the VLT FC 202 AQUA Drives series. The unit modulates three-phase power to regulate centrifugal pumps and blowers used in water-treatment and irrigation systems. By adjusting the output frequency, it allows connected controllers to optimize flow and pressure while reducing the amount of energy drawn from the mains. This operating method also provides smoother pump acceleration than direct line starting, which can reduce sudden pressure changes in connected piping.
The drive accepts a mains voltage range of 380–480 VAC, which is compatible with common industrial supply panels. On 380–440 V lines, it draws a continuous input current of 9.0 A and can deliver 10 A to the motor terminals. When the supply voltage is between 441 V and 480 V, the available output current is 8.2 A. Internal power conversion reaches an efficiency of 0.97, so only a small portion of the incoming electrical power becomes heat. A maximum pre-fuse rating of 20 A protects the input against excessive fault current. The braking circuit supports a 5% duty cycle for intermittent deceleration. To dissipate regenerated energy safely, the braking resistor must have a resistance of at least 135 Ω, while a resistance of 157.3 Ω is recommended for nominal stopping conditions.
The rated mechanical output is 4.0 kW, which is equivalent to 5.0 HP and is suitable for midsize submersible or end-suction pumps. The power electronics dissipate 124 W during full-load operation, and the enclosure can release this heat at ambient temperatures up to 50 °C without derating. Shielded motor leads may extend up to 150 m, providing substantial separation between the drive enclosure and the connected motor. Unshielded motor leads may extend up to 300 m when the installation permits that cable arrangement. These cable allowances provide flexibility when pumps are installed far from the electrical panel, such as in treatment plants, irrigation networks, or distributed pumping stations.
