FC-202P3K7S2131G5531 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-202P3K7S2131G5531 is part of the VLT FC 202 AQUA Drives series and provides a typical shaft output of 3.7 kW with a continuous apparent power of 6.0 kVA. It operates on single phase power with a mains voltage range of 200 to 240 VAC and achieves an efficiency of 0.98. The drive has continuous input and output currents of 32 A and 16.7 A respectively, with a maximum ambient temperature of 50°C.
Internal Product Review
The FC-202P3K7S2131G5531 is a Danfoss VLT FC 202 AQUA drive built for 200 - 240 VAC single-phase power systems. Efficiency of 0.98 and a typical shaft output of 3.7 kW make the unit a strong choice for demanding pump and water handling applications. Support for unshielded motor cable runs up to 300 m adds valuable flexibility for larger installations.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P3K7S2131G5531 is an AC variable-frequency drive produced by Danfoss for the VLT FC 202 AQUA Drives series. This unit is intended for pumping and aeration duties where variable-speed control can improve process efficiency and reduce mechanical stress on connected equipment. It operates from single-phase power and regulates induction motors used in water and wastewater automation. The controller can adjust motor speed to match changing flow or pressure demands in pumping systems.
For continuous operation, the inverter has an apparent power rating of 6.0 kVA and accepts an input voltage range of 200–240 VAC. The input draws a continuous current of 32 A, while the drive reaches an efficiency of 0.98 under nominal operating conditions. Power loss is approximately 74 W, which must be considered when providing ventilation for the enclosure. The continuous motor current is 16.7 A, and a 60 A prefuse protects the mains connection. Control terminals include a digital output capable of sinking or sourcing 40 mA and an analog output that supports loads down to 500 Ω for external indicators or transmitters. The single-phase input arrangement simplifies wiring in decentralized pump panels where three-phase utility power may not be available. Shielded motor cables can extend up to 150 m, while unshielded cables can extend up to 300 m when the drive must be installed away from a remote or submerged motor.
During intermittent overloads, the supply current can reach 35.2 A, and the inverter can deliver 18.4 A to the motor for short acceleration or flushing cycles. The selectable carrier frequency reaches 32 kHz, allowing lower audible motor noise during low-power operation. The electronics can operate at ambient temperatures up to 50 °C without derating. Typical shaft power output is 3.7 kW, making the drive suitable for common 5 hp pump motors. The available overload current supports brief increases in torque when a pump starts under load or clears accumulated material. Cable routing, enclosure airflow, and protective devices must remain within the stated operating limits when the drive is installed in lift stations, treatment systems, or pump skids.
