FC-202P30KT6131H8385 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danfoss FC-202P30KT6131H8385 is part of the VLT FC 202 AQUA Drives series and is rated for 30 kW of power and 40 horsepower, operating on three phase power. This drive has an efficiency of 0.98 and supports a maximum ambient temperature of 50 °C. It features an IE2 energy efficiency class, a maximum disconnect and brake cross-section of 95 mm², and an RFI C2 filter.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P30KT6131H8385 is a variable-frequency drive produced by Danfoss for the VLT FC 202 AQUA Drives series and carries the internal series identifier 202 used across compatible accessories. In water-handling and HVAC plants, it modulates induction motor speed so that pumps and blowers match real-time demand, reducing energy consumption and mechanical stress. Its three-phase power design allows direct connection to standard industrial mains for automated flow or pressure control tasks.
The inverter delivers 30 kW of continuous output power, equivalent to 40 HP, while maintaining a conversion efficiency of 0.98 and complying with the IE2 energy-efficiency class. Its pulse-width-modulated output can be configured for a switching frequency of up to 32 kHz, allowing acoustic optimization of connected motors. Two analog outputs provide 8-bit resolution and can send signals to loads with an impedance of up to 500 Ω. The digital terminal block supplies up to 40 mA for connected status relays or flow switches, and the input topology is suitable for typical plant distribution boards.
For field installation, the drive includes an RFI C2 filter and can operate at ambient temperatures up to 50 °C when applicable cabinet derating requirements are observed. It tolerates relative humidity up to 95% without condensation, and it can operate at altitudes up to 1000 m without derating or 3000 m with a reduced current profile. Line and motor conductors can have cross-sectional areas of up to 150 mm², while brake and disconnect conductors can have cross-sectional areas of up to 95 mm². Shielded motor cable runs may reach 150 m, while unshielded motor cable runs may reach 300 m. An upstream protective device rated at 60 A must be installed to provide appropriate circuit protection.
