FC-202P2K2S2131G7744 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-202P2K2S2131G7744 is part of the VLT FC 202 AQUA Drives series and has a power rating of 2.2 kW with a 3.0 HP output. It supports a mains voltage of 200 to 240 VAC, operates with a 20.5 amp input current, and achieves 0.98 efficiency. This drive features one analog output, two digital outputs, and offers an overload rating of 110% for 1 minute.
Internal Product Review
The FC-202P2K2S2131G7744 is a Danfoss VLT FC 202 AQUA drive built for dependable motor control on 200 - 240 VAC single-phase power. A 2.2 kW rating and 0.98 efficiency give the unit excellent operating economy, making the drive a very strong option for AQUA system service.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P2K2S2131G7744 is a variable-frequency inverter manufactured by Danfoss as part of the VLT FC 202 AQUA Drives series. It is engineered to regulate centrifugal pumps, blowers, and similar equipment in industrial automation systems. By adjusting motor speed to real-time flow or pressure requirements, the drive can lower energy consumption and reduce mechanical wear in water treatment, distribution, and pumping applications.
The drive accepts a mains supply of 200–240 VAC and draws up to 20.5 A from the line. Its inverter section delivers 10.6 A of motor current with a continuous mechanical output of 2.2 kW. With a conversion efficiency of 0.98, the unit dissipates only 44 W of heat under rated load. The control terminals provide one isolated analog output that can source or sink signals into loads as low as 500 Ω. Two digital outputs can each supply 40 mA for relay or counter inputs. The cable set must be rated for 75 °C to remain within temperature-rise limits, while a 40 A upstream fuse protects the rectifier stage from short-circuit faults.
When sized for centrifugal pumps, the inverter has an apparent input demand of 3.8 kVA and a corresponding shaft capacity of 3.0 HP. Short-term transients are handled by an overload reserve of 110% for 1 minute, helping prevent trips during rapid pressure changes. The DC bus can receive dynamic energy through an external brake resistor. Application wiring may use a nominal resistance of 74.1 Ω, while the resistance must not fall below 58.5 Ω during operation. The drive uses single-phase power, so it must be connected to a compatible supply. Series identifier 202 provides water-utility functions such as sleep mode and flow compensation, allowing pump operation to respond to changing demand without continuous full-speed operation.
