FC-202P1K1T6136H9191 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-202P1K1T6136H9191 is a 1.1 kW drive from the VLT FC 202 AQUA Drives series, offering a continuous output current of 2.4 A and a maximum input current of 2.4 A. It has an energy efficiency class of IE2, operates at up to 97% efficiency, and supports three phase power. The drive allows a maximum ambient temperature of 50 °C and can be used at altitudes up to 1000 meters without derating.
Internal Product Review
The FC-202P1K1T6136H9191 is a Danfoss VLT FC 202 AQUA drive built for three-phase applications at 1.1 kW. A 0.97 efficiency rating and 50 W estimated power loss make energy performance notably strong in continuous-duty service. Support for shielded motor cable lengths up to 150 m adds valuable installation flexibility, making this drive a very capable choice for AQUA system duty.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P1K1T6136H9191 is an AC variable frequency drive built by Danfoss for the VLT FC 202 AQUA Drives series. Designed for centrifugal pump and fan duties in water treatment facilities, the unit converts fixed mains power into a regulated output that matches hydraulic demand while reducing energy consumption. By modulating motor frequency and voltage, it helps operators maintain flow or pressure without using throttling valves. It also communicates with higher-level controllers through its drive interfaces.
The power section is rated at 1.1 kW, allowing it to run induction motors in the 1 kW class with reserve capacity for overloads typical of pump startup. It accepts three-phase power and draws a maximum line current of 2.4 A, so a 10 A gG fuse protects the supply. Conversion efficiency reaches 0.97, and approximately 50 W is dissipated as heat at full load, reducing enclosure ventilation requirements. Cable terminations accommodate conductors up to 4 mm². Shielded motor leads may extend 150 m, while unshielded runs can reach 300 m, allowing the drive to operate pumps installed away from the control enclosure.
The output corresponds to 1.5 HP, a value commonly referenced by pump manufacturers when sizing impellers. Full torque is available up to an elevation of 1000 m without derating; above that elevation, the drive can operate at up to 3000 m with a proportional current reduction. It remains functional from a minimum ambient temperature of 0 °C up to 50 °C, covering most indoor pumping stations. The unit conforms to the IE2 energy-efficiency class for variable-speed equipment. The electronics are conformally coated to tolerate a peak relative humidity of 95% without condensation in humid pump galleries. Internal monitoring reports estimated power loss to supervisory systems, allowing cooling performance to be tracked during operation.
