FC-202P1K1T2131N5582 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-202P1K1T2131N5582 is part of the VLT FC 202 AQUA Drives series and features a continuous output current of 6.6 amps with a power rating of 1.1 kilowatts. It is designed for three phase 200 to 240 volt mains voltage, supports a maximum output frequency of 590 hertz, and has an efficiency of 0.96. The drive can operate at ambient temperatures up to 50°C and allows installation up to 1000 meters altitude without derating.
Internal Product Review
The FC-202P1K1T2131N5582 is a Danfoss VLT FC 202 AQUA drive built for reliable variable speed control in pump and fan applications. A 1.1 kW power rating and 1.5 HP capacity make this unit a strong fit for compact water system installations. Fast control behavior with a system response time of ≤2 ms and a 5 ms scan interval supports precise, stable operation.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P1K1T2131N5582 is an AC variable-frequency drive produced by Danfoss for the VLT FC 202 AQUA Drives series. It conditions three-phase power so that pump and fan motors in water-handling systems run only as fast as process demand requires. By matching motor speed to real-time flow or pressure targets, the drive lowers energy use and extends mechanical life. Its compact frame is intended for skids and control panels where space and heat dissipation are limited.
The drive delivers a continuous motor output of 1.1 kW while accepting line voltages between 200–240 VAC. At that rating, the inverter supplies 6.6 A of output current and operates with an efficiency of 0.96, minimizing heat generation under full load. Input requirements remain modest; the supply must provide 5.9 A and 2.38 kVA through a three-phase feeder protected by a 20 A upstream fuse. Internal power electronics generate the commanded waveform, while the motor terminals are filtered for sine-like voltage to limit acoustic noise and insulation stress. Cable lugs up to 4 mm² connect on the drive side. The disconnect device can accept conductors as large as 6 mm² to meet local electrical codes.
The control platform supports a maximum output frequency of 590 Hz for high-speed impeller applications. Reliable operation is maintained at an ambient temperature of up to 50 °C and an installation altitude of up to 1000 m without derating. Digital logic samples feedback every 5 ms, and the closed control loop reacts within 2 ms or less, allowing tight pressure regulation during rapid load changes. Motor leads may be routed through shielded cable runs as long as 150 m without violating electromagnetic compatibility limits. This cable allowance gives installers flexibility when the motor and drive must be mounted in separate parts of a water-handling system.
