FC-202N200T7134N9611 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danfoss FC-202N200T7134N9611 is a variable frequency drive with a rated power of 200 kW and operates on three-phase input voltage ranging from 525 to 690 V AC. Part of the VLT FC 202 AQUA Drives series, it offers a frequency output up to 32 kHz and supports up to 6 digital inputs with a system response time of 2 milliseconds or less.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202N200T7134N9611 is an AC variable-frequency drive manufactured by Danfoss for the VLT FC 202 AQUA Drives series. It is intended for pump and fan duties in treatment plants and distribution networks, where closed-loop automation relies on precise motor speed control to conserve energy, stabilize discharge pressure, and reduce mechanical wear. This model accepts three-phase input at 525–690 V AC and delivers up to 200 kW of shaft power to the connected motor.
Internally, the inverter updates its control loops every 2 ms or less, and the synthesized output frequency can be adjusted in increments of ±0.003 Hz. This fine resolution supports proportional-integral regulation in applications that require accurate control of pressure, flow, or motor speed. Open-loop regulation spans a ratio of 1:100, so the drive can handle low-speed priming and high-speed purge cycles without encoder feedback. Four standard logic terminals and two additional configurable terminals accept 0–24 V DC signals, providing 4 standard inputs and 6 total inputs when the configurable terminals are used. Each digital output can sink 40 mA, while the 10.5 V reference rail supplies pilot devices at 10.5 V ± 0.5 V. A 24 V auxiliary bus rated for 200 mA powers transducers at the panel. For analog tasks, the source impedance must not fall below 500 Ω, and the frequency-tracking relay can switch pulses up to 32 kHz to accommodate turbine flowmeter outputs.
The drive’s feedback layer supports an analog command range of 0/4–20 mA, while a high-speed counter processes encoder or magnetic pickup signals at frequencies up to 110 kHz. Under scalar operation, the speed error remains within ±8 rpm, supporting centrifugal pump applications that require stable rotational speed. The product identifier 202 places the unit in the AQUA drive family, and the power section uses a three-phase connection compatible with industrial utility feeders. Sensor signals can be connected through the available analog and digital interfaces, while the high-speed input accommodates pulse-based feedback devices without separate signal conversion.
