195N1052 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
MPN: VLT2822PT4B20SBR1DBF00A00C0
The Danfoss 195N1052 is part of the VLT 2800 Low Voltage Drives series and has a power rating of 0.55 kW and an efficiency of 96 percent. This drive features an IP20 enclosure, an integral brake module, and offers 5 programmable digital inputs with a maximum voltage of 28 V DC. The 195N1052 weighs 3.7 kg and supports a maximum pre-fuse rating of 20 A.
Internal Product Review
The 195N1052 is a Danfoss VLT 2800 low voltage drive with an integral brake module and integral RFI filter. Efficiency reaches 96%, and the IP20 enclosure suits clean cabinet installations with dependable performance. Starting torque rated at 160% for 1 min makes the unit a strong choice for demanding low-speed drive control.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 195N1052 is a low-voltage AC variable-frequency drive manufactured by Danfoss within the VLT 2800 Low Voltage Drives series. In an automation cell, it converts fixed-frequency three-phase mains power into a modulated output that allows controllers to vary an induction motor’s speed and torque, making it suitable for conveyors, pumps, and small material-handling machines. An integral brake module supports dynamic braking by dissipating regenerated energy during rapid deceleration. The built-in radio-frequency interference filter also reduces conducted electrical noise without requiring a separate filter.
This drive operates with an energy conversion efficiency of 96%, so only a small portion of the input power is dissipated as heat. Under nominal conditions, it draws a continuous line current of 8.1 A and provides a rated motor output of 0.55 kW. The inverter can supply a maximum continuous output current of 5.2 A, making it suitable for compatible F-class induction motors. To overcome static friction or start loaded fans, the control algorithm provides 160% starting torque for 1 minute. Five programmable digital inputs allow local controls or a PLC to select speed references, issue start commands, and activate preset acceleration ramps without additional input modules.
For short overloads, the rectifier and DC link can accept an input surge of 13.0 A for 60 seconds, enabling rapid acceleration or brief process disturbances without an immediate trip. The control terminals accept signals up to 28 V DC, allowing direct connection to standard 24 V industrial logic. The housing has an IP20 ingress protection rating and is intended for installation inside an enclosed control panel. The unit weighs 3.7 kg, which reduces the mounting load on DIN rails or backplates. The recommended upstream fuse rating is 20 A, and the power terminals accept cables with cross-sectional areas up to 4 mm², equivalent to 10 AWG. Power loss can reach 200 W during full-load operation, so the enclosure must provide adequate ventilation and clearance around the drive.
