Product Description:

The 195N1008 is an AC variable-frequency drive produced by Danfoss within the VLT 2800 Low Voltage Drives series. As a book-style module, it occupies minimal cabinet width while delivering closed-loop speed control for process motors in conveyors, pumps, and mixers. The drive connects directly to plant power networks through its three-phase mains terminals and integrates a built-in SLCP display for local parameter entry, status readings, and brake diagnostics. No additional application option card is installed.

The inverter’s motor output is rated at 0.55 kW, which corresponds to 0.75 HP and provides enough continuous capacity to control small induction machines used in auxiliary skids and dosing stations. It accepts a supply of 380–480 V AC at either 50 Hz or 60 Hz and draws only 1.6 A from the line under nominal load. Overall conversion efficiency reaches 96 %, which keeps enclosure temperatures moderate and reduces the heat load on surrounding electronics. At full output, internal losses are limited to 28 W. This value can be used when sizing forced-air cooling or heat sink surfaces around the drive.

For transient events such as rapid acceleration, the current limit permits up to 2.7 A for sixty seconds, while continuous motoring is capped at 1.7 A. The housing carries an IP20 rating, so it must be mounted inside a protected cabinet but does not require additional finger guards. Motor data can be entered in either metric or imperial units. Standard hardware includes an integrated brake chopper, an EN 55011 Class A1 RFI filter for conducted emissions, and terminals prewired for three-phase output. The 2.1 kg mass reduces the load on the cabinet mounting surface and makes the unit easier to position during installation. The uncoated circuitry is suitable for clean industrial environments where protection from heavy moisture or corrosive contaminants is unnecessary.