195N0031

Product Description:

The 195N0031 drive from Danfoss lands in the VLT 2800 Low Voltage Drives group and takes on steady motor control for smaller industrial tasks. With a power rating of 0.75 kW, the output matches up well for conveyors or pumps needing just enough push but stable operation over long runs. Maximum output frequency taps 120 Hz when using an LC filter, giving extra room when application speeds shift a lot. Direct mounting stays simple because installation only allows vertical placement, and a factory-applied RFI filter sits pre-installed to knock back unwanted electrical noise in fussier work areas.

The control options go further with Profibus DP 3 Mbit/s bus communication baked in, connecting the drive to remote controllers or making real-time tweaks simpler. Rated at IP20 for enclosure, the housing keeps hands out but doesn’t close everything off like heavier-duty sealing might—best in cleaner industrial bays or enclosures. Standard input lets it handle single-phase 220-240 V or three-phase 200-240 V feeds with no fuss, which covers plenty of shop floors without special wiring. Physical setup feels compact too, sitting at just 200 x 90 x 152 mm and weighing 3.8 kg—easy to move or swap when needed.

Inside, the drive cools itself (classified as self-cooled) so there’s no dependance on building-wide systems or open-air fans. The switching frequency reaches 4500 Hz, a number that suits stable torque with minimal buzz or vibration making its way through the wire. For compliance, EN 55011-1B RFI limits are met, knocking out headaches when lining up certifications. Usually, this drive pairs into small machine setups, packaging systems, or spots where controls sync over Profibus and space stays tight. In all, the 195N0031 checks off quiet operation, communication readiness, and a tough reputation for a low-kilowatt category.