175G9000

Product Description:

The 175G9000 made by Danfoss shows up in the Danfoss Cables and Accessories range, meant for wiring and data link setups around soft starters or automation machines. This accessory sits light at 0.25 kg but holds up well for most installs. Its design stands out because of those spring-action plastic clips, making it quick to attach on mounting rails or close spaces where tools can’t always reach. There’s a 6-way pin assembly built in, matching most soft starter connections without fuss.

Users get a lot of flexibility from the 5-way male/female network connector, letting this accessory work with many types of network hardware. Supported data run clear across speeds—4800, 9600, 19200, and 38400 bps—so setups that change later still accept it without needing new gear. The parity options offered (“None, Odd, Even, 10-bit”) make finding the right match for each factory easier than with old single-type parts. With a maximum cable cross-section of 2.5 mm², it covers lots of standard wiring jobs without being tricky to fit through conduit or across block terminals.

Installers find the compact 40 mm x 166 mm x 90 mm body keeps panels from feeling crowded. A protection rating of IP20 is part of the build—good for indoor enclosures that stay mostly clean. Data address settings go 0–31 for flexible expansion in daisy-chain situations or bus networks. Whether on control panels for conveyor systems or small device pods, this accessory supports steady communication and keeps wires fixed without slipping over time. Not too complicated to configure, this piece comfortably covers both speed and reliability needs for cable interfacing on new or replacement automation jobs. Its plain build and reliable fixings help it do just what’s needed and little else.