060G2850

Product Description:

The 060G2850 display unit from Danfoss, built within the Danfoss Cables and Accessories series, lands as a reliable solution for industrial signal monitoring. At a glance, the body is compact but packs utility, made to support a 4–20 mA input signal which shows up often in many process control setups. Visibility pulls ahead with the LCD, 10 mm digit height display—clear digits from a distance mean less squinting on crowded panels. This unit steps in where quick readings need to be sharp and simple.

Taking a hit from rough environments isn't a problem for the 060G2850. The outer case brings IP65 ingress protection, so spray, dust, and even some water jets get turned away. Housing mixes ABS and a polycarbonate front, securing the electronics inside. Installation gets easier because the design stays small at 48.5 × 48.5 × 35.5 mm. Even in tight racks, that size fits where large screens won’t. A voltage drop of approximately 3 V works fine for most common current loop circuits. Adjustments show up in the form of a selectable decimal point, so there’s control over how data appears depending on what’s needed.

Measuring accuracy is marked at 0.2% ± 1 digit, with a display range going from -1999 up to 9999 for a broad collection of readouts across sensors and transmitters. Measurement interval sits near 3 measurements per second, so there’s no lag to keep an eye on process changes. Temperature drift clocks at 100 ppm/°C, so results keep steady in hotter spots. Humidity tolerance stretches from 0–80% RH non-condensing, meaning locker rooms or washdown areas aren’t off limits. Setups usually see units like this on production lines, lab panels, or pumping stations where feedback from sensors is key and readability in harsh spots is a must for quick, accurate checks.