Q7005-14 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher Q7005-14 is a regenerative drive from the Quadraline Regenerative Drives series, designed for continuous duty cycles and supports a speed range of 50 to 1. It operates on a single-phase 230 VAC input voltage at 50/60 Hz and can handle altitudes up to 3300 feet with a chassis temperature up to 55°C. The drive features a bipolar isolated signal interface and has a pulse tachometer with a maximum frequency of 3600 Hz and voltage of 100 V.
Internal Product Review
The Q7005-14 is a Danaher Quadraline regenerative drive built for continuous duty and single-phase input operation. A 230 VAC ±10% input rating with 50/60 Hz ±2 Hz compatibility supports stable integration across standard industrial power systems. Strong overload handling at 150% for 1 minute makes the unit a dependable choice for controlled regenerative drive performance.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The Q7005-14 is a regenerative DC drive manufactured by Danaher as part of the Quadraline Regenerative Drives series. Designed for industrial automation, the unit returns excess kinetic energy to the supply while controlling DC motors in material-handling and process equipment. This configuration improves energy use and allows bidirectional speed regulation without external braking resistors. The drive forms the power stage between single-phase utility lines and permanent-magnet or shunt-wound motors, integrating easily into panels that require compact energy-recovery solutions.
The drive uses a single-phase input and accepts an input voltage of 230 VAC ±10%, allowing installation on common utility feeders. The incoming line is protected by a 60 A fuse, and the control section tracks mains cycles at 50/60 Hz ±2 Hz, so no jumper changes are needed when moving between regions. Danaher rates the power section for a continuous duty cycle and a maximum overload of 150% for 1 minute; this short-term headroom covers acceleration surges and vertical load reversals. Motor speed can be regulated across a 50:1 range, giving low-speed torque without shaft encoders. All control signals are routed through a bipolar isolated interface that keeps high-energy circuits from coupling noise back into PLC I/O.
For installation in closed cabinets, the heat-sink temperature must stay below 55 °C, while the surrounding enclosure air is limited to 40 °C; forced ventilation is therefore recommended when the chassis is loaded near its continuous rating. The drive maintains full performance up to 3,300 ft (1,000 m) of elevation without derating. Feedback can be supplied by an AC pulse tachometer; the controller accepts up to 3600 Hz of pulse frequency at amplitudes as high as 100 V, with a resolution of 60 pulses/rev. This capability lets the speed loop react quickly while keeping wiring simple when retrofitting older motors.
