Product Description

The HS35R50006141 Danaher hollow-shaft encoder does not get misaligned like solid shaft encoders. This encoder depicts an overall compact size as there are no additional clamping elements. The product needs no specific size to fit onto the corresponding motor. This device features reduced wear and tear as it has only a few components. The unit portrays an enclosed design that gives it additional protection. Its design allows it to address space constraints while delivering accurate feedback. This encoder uses a reference system to calculate its motion.

The product’s integrated sensor array produces two primary signals in its PCB. This device delivers dependable outputs with its phased array optics that are integrated in its design. The unit features a 90° +/-30° electrical phasing. It comes with large-sized ABEC1 bearings. This encoder supports a minimum 1.25-inch shaft engagement length. The product’s back is covered and protected by an endcap. This device has lengthened tether holes for tether arcing if the hole location is not aligned with the tether surface. The unit’s housing must at all times be secured against wobble. It must not be used if there is a distortion or bending of the tether.

This encoder’s mating shaft must comprise a minimum length of 1.25% of the shaft length of the encoder. The product encompasses no LED output. This device features alignment and positioning with ease. The unit’s endcap protects it from mechanical damage during its installation and handling. Its optical disc is shatterproof and is made of aluminum. This hollow-shaft encoder’s tether has to be rotated to the desired orientation and tightened in place.