HS35R0360D10H Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danaher HS35R0360D10H is an encoder from the Dynapar Encoders series with a 360 PPR resolution and a maximum shaft speed of 3600 RPM. It has an axial shaft load capacity of 30 pounds and a radial shaft load of 40 pounds. The enclosure rating is NEMA 4/IP66 and the encoder can withstand up to 98% relative humidity.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The HS35R0360D10H is a hollow-shaft incremental encoder produced by Danaher within the Dynapar Encoders series. In automation cells, it supplies rotational position data to drives and PLC counters for closed-loop motion control. Its speed signal also supports monitoring and interlock functions on conveyors, winders, packaging axes, and other rotating machinery.
With a maximum shaft speed of 3600 rpm, the encoder can mount directly on medium-speed motors without a reduction stage. Its optical disc provides 360 PPR, so each electrical cycle corresponds to one mechanical degree and provides predictable scaling for motion profiles. A sealed housing rated at NEMA 4/IP66 blocks dust and resists powerful water jets, permitting installation near coolant spray or outdoor equipment. Internal electronics draw no more than 100 mA, reducing heat rise in sensor buses that operate from 5 V to 26 V. The encoder withstands shocks of up to 50 G for 11 ms, helping the optical assembly tolerate brief mechanical impacts. Running torque is limited to 4.5 oz-in during operation, while starting torque remains below 5.0 oz-in, minimizing resistance on small servomotors. Its total mass remains below 16 oz, which reduces overhung loading when the encoder is attached to a motor shaft.
The bearings support an axial load of 30 lb and a radial load of 40 lb. These load capacities accommodate the thrust and side forces that can result from belt tension, shaft movement, or minor mounting misalignment. Signal fidelity is maintained because the incremental channels operate at frequencies up to 100 kHz, allowing the encoder to track rapid shaft movement without losing pulse information. Signal transitions have leading and trailing edge times within 1 µs, providing clean pulse timing for compatible counters and drive inputs. Operation remains stable at ambient humidity levels up to 98 % RH, while the sealed enclosure limits moisture entry in damp industrial locations. The combination of low operating torque and supported shaft loading suits installations on press rolls, mixers, and gear reducers where the encoder may experience continuous rotation and multidirectional mechanical forces.
