HR62503600601 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher HR62503600601 is an encoder in the Dynapar Encoders series with a resolution of 360 pulses per revolution and a frequency response of at least 100 kHz. It features an enclosure rated NEMA4/IP66 and can operate at shaft speeds up to 10,000 RPM. The device weighs 1.5 pounds and supports shaft loading up to 80 pounds both radially and axially.
Internal Product Review
The HR62503600601 is a Danaher Dynapar encoder with 360 PPR resolution and a 100 kHz minimum frequency response. NEMA 4/IP66 protection and 10,000 RPM maximum shaft speed make the unit a strong fit for demanding motion feedback duties. A well-executed encoder for applications that value stable signal quality and dependable service.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The HR62503600601 is an incremental rotary encoder manufactured by Danaher within the Dynapar Encoders series. Mounted to a drive or actuator shaft, the unit generates evenly spaced pulse signals for motion feedback. A motion controller counts these signals to determine shaft position and velocity, allowing precise speed regulation and positional verification in automated machinery.
Signal fidelity is supported by a base resolution of 360 PPR, producing 360 pulses per revolution for fine angular measurement. The output stages respond to switching frequencies of at least 100 kHz, enabling accurate feedback on high-speed spindles. Square-wave transitions have rise and fall times of less than 1 µs, which reduces timing uncertainty in high-bandwidth control loops. Proper phase separation is maintained, with channel A leading channel B by 90° ± 22.5° electrical. Duty-cycle symmetry remains within 180° ± 18° electrical, limiting cycle-to-cycle jitter. Rotational inertia is kept low at 3.0 × 10-4 oz-in-sec², minimizing the load on small servo motors and permitting rapid acceleration without significant lag.
The shaft can rotate safely at speeds up to 10,000 rpm. The stainless-steel hub supports loads of up to 80 lb radial and 80 lb axial without bearing damage. Total indicated runout does not exceed 0.001 in, preserving encoder accuracy when the unit is coupled to precision shafts. A positive lip seal surrounds the shaft opening, and the housing meets the NEMA 4/IP66 enclosure classification to block dust and high-pressure water. The permitted storage temperature ranges from -40 °C to +90 °C, protecting the unit during transportation or extended line shutdowns. The encoder weighs 1.5 lb, which reduces the load placed on its mounting panel or support bracket.
