H232048104135PS Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danaher H232048104135PS is part of the Dynapar Encoders series and has a resolution of 2048 PPR with a quadrature ABZ output format. It features a maximum shaft speed of 5000 RPM, operates within a temperature range of 0 to 70°C, and comes with a NEMA 12 / IP54 enclosure rating. The encoder supports a supply voltage of 5 to 26 VDC and uses a 10 pin side MS connector for termination.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The H232048104135PS is an incremental rotary encoder manufactured by Danaher and assigned to the Dynapar Encoders series. It mounts on a drive or conveyor shaft and converts mechanical rotation into timed pulse trains that a PLC or servo drive can count for position, direction, and velocity feedback in automated equipment. A pilot diameter of 1.25 in centers the flange against matching motor faces, while the 3/8 in solid shaft couples with standard flexible or rigid hub clamps.
The housing carries a dual-rated seal of NEMA 12 / IP54, which blocks dust intrusion and light splashing when the unit is properly installed. An internal optical disc and sensor pair provide a minimum frequency response of 100 kHz, allowing the electronics to resolve high rotational rates without pulse dropout. The maximum shaft speed is 5000 rpm, providing mechanical overspeed capacity for demanding motion applications. Each revolution produces 2048 PPR, giving fine angular resolution for precise position and velocity control. The encoder electronics accept a supply range of 5–26 VDC, allowing the device to operate from common logic supplies or 24-volt control buses. Its operating temperature ranges from 0 to +70 °C, supporting use in many industrial enclosures without dedicated cooling. The housing and shaft arrangement also permit direct installation near motors, pulleys, and conveyor components where rotational feedback is required.
Startup friction is limited to a maximum of 1.0 oz-in, minimizing the additional load placed on small servo motors during acceleration. Radial or axial forces of up to 40 lb can be applied to the shaft without reducing bearing life, which supports belt-pulley and gear-drive installations. The signal electronics draw no more than 80 mA, helping control total power demand in multi-axis systems. The differential driver provides outputs in quadrature ABZ format, supplying two phase-shifted channels and an index signal for homing routines. Connection to the control panel is made through a 10-pin side MS connector, which allows the encoder cable to be disconnected without disturbing panel-side wiring.
