H231024104135PS Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danaher H231024104135PS is part of the Dynapar Encoders series and is equipped with a 10 pin side mount connector and a flange mount housing. This encoder supports a maximum shaft speed of 10000 RPM, axial and radial loads of 80 pounds, and outputs a 7272 differential line driver signal. It has a resolution of 1024 pulses per revolution and an enclosure rating of NEMA12/IP54.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The H231024104135PS incremental rotary encoder is produced by Danaher for the Dynapar Encoders series. As a feedback element, it translates shaft rotation into digital pulse streams that allow drives, PLCs, and motion controllers to measure speed and establish precise positional references inside automated equipment. The device mounts with a flange interface and integrates a male pilot so it can be seated concentrically on motor end bells, conveyors, or unwind stands. By supplying electrically isolated differential channels, it supports closed-loop regulation without adding undue electrical noise to the control cabinet.
In service, the encoder outputs 1024 PPR on its quadrature A and B channels while adding an index Z pulse for homing routines. A 7272 differential line driver buffers these signals, producing complementary pairs that tolerate long cable runs and reduce electromagnetic interference. The electronics have a minimum frequency response of 100 kHz, preventing missed counts during rapid changes in rotational speed. The supply current is limited to a maximum of 80 mA, so several encoders can share the same 5 V rail. The 10-pin side-mounted connector simplifies cable attachment and removal during equipment servicing. Starting torque remains below 1.0 oz-in to avoid adding excessive friction to lightly loaded shafts.
The unit tolerates an axial thrust of 80 lb, allowing direct coupling to gearboxes or rollers without external bearings. The output shaft has a diameter of 3/8 in., and the internal 1.25 in. male pilot aligns the encoder with the driven member to minimize eccentricity. Continuous operation is rated up to 10,000 rpm, supported by precision bearings and a balanced code disk. The enclosure meets NEMA 12/IP54 requirements, blocking airborne dust and water splashes encountered on typical plant floors. Radial capacity matches the axial rating at 80 lb, while the rigid aluminum housing keeps the disk gap stable under vibration. These load capacities allow the encoder to withstand forces transmitted through directly connected machine components.
