M.1302.7612 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher M.1302.7612 is part of the Block IO Analog Modules series and features five DC inputs and five encoder inputs, each with 24-bit encoder position resolution. It supports up to 4 Amps per-phase peak current and a maximum DC input voltage of 30 VDC. The module allows up to 500 command queue depth and operates within a temperature range of 5 to 55 degrees Celsius.
Internal Product Review
The M.1302.7612 is a Danaher Block IO analog module with 5 stepper channels and 5 encoder inputs. Technical performance stands out through 24-bit encoder position resolution and a 500-command queue depth, supporting accurate motion feedback and efficient command execution. A 4 A peak per-phase current rating makes the unit a highly capable choice for compact multi-axis control.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The M.1302.7612 block I/O analog module from Danaher belongs to the Block IO Analog Modules series and integrates discrete and motion-oriented signal processing into a single DIN-rail unit. Designed for machine cells that need coordinated stepper, encoder, and sensor interfacing, the module supplies logic power to downstream devices while forwarding field data to the PLC over a backplane bus. Inside a compact enclosure, it handles DC input, encoder, and stepper interfaces to synchronize small drives or actuators in industrial automation applications.
The module accepts field power up to 30 VDC, allowing sensors or contact switches to be wired directly without separate signal conditioners. An input registers a logic-low state when the line falls below 5 VDC and transitions to a logic-high state once it exceeds 15 VDC, providing noise immunity on extended wiring. Five sinking or sourcing DC inputs share these thresholds, and the same header supports five stepper channels that can deliver up to 4 A peak per phase to miniature motors over cable runs limited to 100 ft. Encoder feedback captures absolute position at a resolution of 24 bits, while the onboard electronics draw 300 mA of logic power from the control supply.
Buffered motion instructions are stored in a FIFO with a capacity of 500 commands, so velocity and position updates do not congest the network bus. Each encoder input can also be polled through an SSI interface clocked at 250 kHz, matching typical timing requirements for 24-bit sensors. Continuous service is permitted from 5 °C up to 55 °C, while the unpowered assembly can be stored at temperatures ranging from -40 °C to 85 °C. These operating and storage ranges accommodate installations in standard control cabinets and on protected machine frames where temperatures may vary between production and shutdown periods.
