VT1600-S-20 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
The Bosch Rexroth Indramat VT1600-S-20 is part of the VT 1600 Servo Amplifiers series and weighs 0.15 kilograms. The card features dimensions of 100 mm in height and 160 mm in width, with a front plate height of 128 mm. It has a coil resistance of 2000 ohms, operates with a dither frequency of 340 Hz, and provides a power supply current of less than 200 mA.
Internal Product Review
The VT1600-S-20 is a Bosch Rexroth Indramat servo amplifier designed for precision control, featuring a 340 Hz dither frequency and 3 mApp dither current for enhanced valve response. With three PID adjusters and a power supply current below 200 mA, this unit offers reliable and efficient performance for industrial automation. Its compact form factor makes it suitable for tight control panel installations.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The VT1600-S-20 is a plug-in servo amplifier card produced by Bosch Rexroth Indramat for the VT 1600 Servo Amplifiers series. Installed in a 19-inch rack, the card conditions command signals and delivers controlled coil current to proportional or servo valves. Within an automated cell, it closes the analog loop between a motion controller and a hydraulic actuator, converting low-level voltage references into the regulated power needed for accurate position, pressure, or flow regulation in machine tools, presses, and material-handling equipment.
The module follows Eurocard mechanics with a card height of 100 mm and a card width of 160 mm, allowing direct insertion into standardized backplanes. A front plate height of 128 mm provides space for test pins and trim potentiometers while fitting the rack opening without obstruction. At just 0.15 kg, the lightweight board minimizes load on guide rails. The power stage is matched to valve coils having a resistance of 2,000 ohms, which limits current draw and reduces heat generation. The compact format and matched coil resistance suit densely populated enclosures where thermal budgets are restricted.
Dynamic control elements are optimized for noise reduction and valve hysteresis. A built-in dither generator supplies 3 mApp at a frequency of 340 Hz, superimposed on the DC output to help overcome friction in the valve spool. The board’s logic circuitry and op-amps run from a supply that draws less than 200 mA, keeping auxiliary power demand low. Command relays switch in 1 ms, enabling rapid enable or inhibit actions without significant wear. Three separate PID adjusters allow independent setting of proportional gain, integral time, and derivative response, so the amplifier can be tuned to a wide range of hydraulic axes without external programming tools.
