VT-VARAP1-537-20/V0/5/3V Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
The Bosch Rexroth Indramat VT-VARAP1-537-20/V0/5/3V is an electric amplifier from the VT-VRPA Electric Amplifiers series with a nominal supply voltage of 24 VDC and a typical power draw of 55 watts. It features PID control action, a plug-in DIN 41612-F32 connection, and a solenoid maximum current of 3.7 amps. The device weighs 0.49 kilograms and has a command input resistance of 100 kilo-ohms.
Internal Product Review
The VT-VARAP1-537-20/V0/5/3V is a Bosch Rexroth Indramat electric amplifier with PID control action and a 24 VDC nominal supply. A 100 kΩ command input resistance and DIN 41612-F32 plug-in connection support clean integration in valve control panels. Strong output performance for size 10 valves is reinforced by a 3.7 A maximum solenoid current.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The VT-VARAP1-537-20/V0/5/3V is a plug-in electric amplifier manufactured by Bosch Rexroth Indramat for the VT-VRPA Electric Amplifiers series. Installed in a 19-inch rack, the card interfaces between a motion controller and a proportional valve, scaling reference signals and driving the valve solenoid on size 10 hydraulic manifolds. Within an automation loop, it closes the position or flow control circuit by turning low-level electrical commands into regulated coil current that positions the valve spool.
The amplifier operates from a nominal bus voltage of 24 VDC, and its electronics can draw up to 2.7 A during demanding transients. Closed-loop behavior is handled by a PID network that adjusts coil current according to positional feedback, while a command input impedance of 100 kΩ ensures that upstream signal sources are not heavily loaded. Drive energy reaches the actuator through a single output stage rated for a maximum solenoid load of 60 VA, allowing the card to energize proportional coils without external boosters. Diagnostic circuitry includes an open-collector error channel capable of carrying 100 mA, so PLC inputs can monitor fault status without relay isolation. This arrangement supports direct communication of operating faults to the connected control system.
An internal sensor rail provides +15 V, and its return leg is fixed at -15 V to supply displacement transducers and LVDTs mounted on the valve. The card can deliver up to 3.7 A of controlled current to the solenoid, and the reference channel supports a 10 kΩ signal-source potentiometer for manual bias during setup. Under normal duty, the board typically dissipates 55 W, so cabinet airflow must remove that heat to keep component temperatures within operating limits. A DIN 41612-F32 connector carries all power, command, and feedback lines, simplifying rack wiring and module installation. Mechanical loading on the rack is minimal because the module weighs only 0.49 kg, while the housing shields the circuitry from vibration common around hydraulic power units.
