VT-MSPA1-30-10/V0/0 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R901288145
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat VT-MSPA1-30-10/V0/0 is part of the VT-MSPA Drives series and features an operating voltage of 24 V with power consumption below 48 W. It has a protection class of IP20, supports cable lengths up to 50 meters, and weighs 0.14 kilograms. The drive comes with a 3.15 A time-lag external fuse and must be installed in a vertical position.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The VT-MSPA1-30-10/V0/0 drive module is supplied by Bosch Rexroth Indramat within the VT-MSPA Drives series. It conditions control power for proportional devices, linking machine controllers to hydraulic or electromechanical actuators in automated systems. A permitted cable length of 50 m allows the electronics to remain in a protected cabinet while the solenoid is installed on the machine. The unit is intended for vertical mounting, which allows air to rise naturally through its open sides and dissipate heat without fans.
During normal operation, the module accepts an input of 24 V DC and converts it to a regulated output that can drive a valve coil with up to 2.7 A of solenoid current. Overall power consumption remains less than 48 W, helping limit electrical losses and heat generation inside the cabinet. The control stage presents a 100 Ω input load, while the power amplifier supports a field-side load impedance of 1000 Ω. The circuit progresses from a cold start to a ready state in less than 1 s, reducing the delay after a power cycle. The electronics are enclosed in an IP20 housing, which protects against accidental finger contact while remaining open to convection cooling. These operating characteristics support direct control of proportional valve coils through long field cables.
Steady-state current consumption remains less than 2 A, permitting use with common plant power supplies. A 3.15 A time-delay external fuse isolates electrical faults while accommodating inrush current, which briefly peaks at the 4 A switch-on rating. Output quality is maintained by limiting residual ripple to 2.5 Vpp, supporting precise load control even when long field cables are connected. An input resistance of 200 kΩ minimizes the electrical burden on upstream signal sources. The assembly weighs 0.14 kg, making it suitable for compact control cabinets where mounting space and supported mass are limited. It can be installed vertically at altitudes up to 2000 m without derating.
