Product Description

The VT-HNC100-C-3X/P-S-00/000 digital axis control launched by Bosch Rexroth is a compact version for one axis. This NC control can be programmed according to the application. The product might pose a risk of injury or damage due to non-compliance with safety and usage instructions. The device works with Version 6 or Version 7 of the related WIN-PED software. This unit features an electric assembly. It supports differential pressure control and pressure/force control.  Digital control is characterized by multiple mating connectors. The product is associated with component series 30 to 39. This device incorporates one PROFIBUS DP interface for its bus connection. It has no specific transport instructions that have to be followed.

This control requires acclimatization for several hours to avoid water from condensation that tends to occur inside its housing. The product has a minimum protection rating. The device encounters major potential differences when its plugs are either connected or disconnected under voltage. The unit incorporates a 32-bit power PC. It is not to be utilized before it has been commissioned. The control has two analog current inputs and analog voltage outputs. The product is fitted to the control cabinet using a top hat rail assembly. This device must have a short voltage supply connection. The unit wiring is supposed to be implemented such that its load, as well as signal lines, are not connected in parallel.

The product must feature pre-assembled breakout cables at its X8M connector. The device connection to the back wall of the control cabinet is done through the DIN rail and its housing. The cable shield of the unit requires clamping under the pull relief. The shield is connected to the housing through the shield pin of its Micro Combicon connector. The input voltage rating of this product must adhere to the requirements of the encoder if a 24V encoder is used. This compact control with one year warranty is sent to any address.