VT-HNC100-1-2X-W-08-0-B Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R900618718
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat VT-HNC100-1-2X-W-08-0-B is part of the VT-HNC Digital Axis Controllers series and is designed for use with one hydraulic axis. It features 8 digital input/output channels, 2 current output channels, and 4 voltage input and output channels. This controller supports wall mounting, has a power consumption of 8 watts, and weighs 1.0 kg.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The VT-HNC100-1-2X-W-08-0-B is a digital axis controller built by Bosch Rexroth Indramat for the VT-HNC Digital Axis Controllers series. It commands one hydraulic cylinder in closed-loop position or velocity applications, converting electronic setpoints into proportional valve motion for presses, die-casting cells, and laboratory rigs. By combining analog and digital I/O with onboard processing, the device supervises cylinder movement and relays status information to higher-level PLCs through a serial service link. This layout supports precise hydraulic motion where repeatable valve response and direct feedback handling are required.
It is configured for 1 hydraulic axis, so its internal control loops and parameter sets are intended for a single proportional valve bank. Four voltage input channels accept command or feedback signals, four voltage output channels drive valve electronics, and two current outputs support magnet-actuated devices. Eight digital input/output points handle limit switches and sequence steps, while power demand remains limited to 8 W. The enclosure measures 71 × 155 × 204 mm, which supports compact wall placement. Flash memory of 1 MB stores operating software and motion parameters, and the encoder capture circuit tolerates rates up to 250 kHz for high-resolution position feedback.
Control tasks are executed by a MC68376 (16/32-bit) microcontroller, which supports deterministic cycle timing for valve modulation. Working data reside in 256 KB of RAM, while an 8 KB EEPROM retains calibration constants for two DM15/4 inductive sensors after power is removed. Because the device is supplied without a fieldbus, setup and data exchange occur through its RS232 (9.6 KBaud) service port. This Series 2 hardware is intended for wall mounting and, including its metal housing, weighs 1.0 kg. The compact mass makes it suitable for light control panels where mounting space is limited.
