VT-HNC100-1-22-W-08-0-0 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
The Bosch Rexroth Indramat VT-HNC100-1-22-W-08-0-0 belongs to the VT-HNC Digital Axis Controllers series and is designed for controlling one hydraulic axis. It features 4 analog input channels, 4 analog voltage outputs, and 8 digital inputs or outputs. The controller weighs 1 kg, has a power consumption of 8 W, and is intended for wall mounting.
Internal Product Review
The VT-HNC100-1-22-W-08-0-0 is a Bosch Rexroth Indramat digital axis controller configured for 1 hydraulic axis. Four analog input channels and four analog voltage outputs give the unit strong flexibility for precise closed-loop control. Wall mounting and 8 W power consumption make the design efficient and easy to integrate.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The VT-HNC100-1-22-W-08-0-0 digital axis controller is produced by Bosch Rexroth Indramat for the VT-HNC Digital Axis Controllers series, which is part of the Digital NC control HNC100 product series. Delivered as the version for one hydraulic axis, the unit provides closed-loop motion commands that synchronize cylinders and valves inside automated presses, handling stations, and test rigs. Because this model is supplied without a bus connection, it integrates directly through the analog and digital lines.
Four analog input channels accept ±10 V references, and the unit also has four analog voltage outputs that generate drive commands for proportional valves. The input stage presents 200 kΩ ±2% resistance so transducers are not heavily loaded, while its conversion increment is 5 mV, giving the controller fine positioning capability. Eight bidirectional digital I/O lines accommodate limit switches, pressure contacts, or ready signals. A 16/32-bit MC68376 processor executes real-time code that resides in 256 KB of fast RAM and boots from 1 MB of flash EPROM, while an additional 8 KB EEPROM stores user parameters. The firmware also allows operation even when no inductive position sensor is installed.
Component series 2 equipment such as this controller is sized for compact panels: the housing stands 155 mm high, spans 71 mm in width, and reaches 204 mm in depth. Continuous operation requires only 8 W of power, which helps reduce heat buildup in dense cabinets. Wall-mounting hardware is built in, which simplifies installation and removal, and the single-piece body weighs 1.0 kg. Each voltage output can source or sink ±10 mA, letting the analog channels drive most valve coils directly. With no fieldbus hardware on the rear plate, wiring is limited to sensor, valve, and supply conductors, which helps keep the panel layout orderly.
