VT 5005 S13A Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
39 Seconds
The Bosch Rexroth Indramat VT 5005 S13A is an IO card from the VT-5000 IO Cards series, featuring a card size of 100 by 160 millimeters and a 32-pin DIN 41612 Form D connection type. It supports a driver load capability of 30 mA, operates at 24 VDC with a fuse rating of 2.5 A T, and weighs 0.15 kilograms.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The VT 5005 S13A is an I/O driver card manufactured by Bosch Rexroth Indramat for the VT-5000 IO Cards series. Installed in a 32-bit backplane rack, the board provides the intermediate drive and monitoring functions that connect low-power controller logic to hydraulic solenoid loads used in automated machinery. It follows the standard Eurocard format, allowing signal channels to be changed without requiring field devices to be rewired. This arrangement supports centralized control of proportional hydraulic valves while keeping logic circuits separated from higher-current output paths.
The card operates at a nominal 24 VDC operating voltage and remains functional from 22 V to 35 V, allowing cabinet power supplies with moderate ripple to remain within the permitted range. A regulated output of ±9 V ±1% supplies the internal comparators, while the enable input becomes active when its level exceeds 8.5 V. Each transistorized channel supports a driver load of up to 30 mA at a logical-high amplitude of 5 V. Control timing comes from an onboard crystal operating at 2.5 kHz ±10%, which supports consistent pulse widths when proportional valves are actuated. For short-circuit protection, the supply rail passes through a 2.5 A T fuse that helps prevent damage to tracks and connectors during wiring faults.
The board uses the standard 100 × 160 mm card size and has a front panel height of 128.4 mm, allowing direct insertion into compatible DIN housings without additional spacers. Field and bus conductors connect through a 32-pin DIN 41612 Form D connector, which groups logic and power pins on one header and simplifies access to the electrical connections. The board weighs 0.15 kg, limiting stress on card guides when installed in cabinets exposed to vibration. Each output can energize hydraulic coils drawing 1.8 A ±20%; the associated solenoid path has a resistance of 5.4 Ω and passes through a relay with a coil resistance of 2,150 Ω. The compact board format leaves room for adjacent control cards while the connector arrangement keeps field wiring concentrated at a single interface.
