VT 5005-13 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
6 Minutes
6 Seconds
The Bosch Rexroth Indramat VT 5005-13 is an IO card from the VT-5000 IO Cards series, measuring 100 x 160 mm and weighing 0.15 kg. It operates with a voltage of 24 VDC, has a current consumption of less than 2 amps, and uses a 32-pin DIN 41612 form D connector. The card supports a relay coil resistance of 2150 ohms and is protected by a 2.5 amp fuse.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The Bosch Rexroth Indramat VT 5005-13 is a plug-in board from the VT-5000 IO Cards series that equips electrohydraulic systems with digital and analog interface points. The card inserts into a standardized rack so PLCs or motion controllers can issue commands and read status through a common backplane. Within an automation cell, it converts 24-volt control logic into drive signals suited for proportional solenoids, relays, and feedback circuits, eliminating separate terminal strips and keeping wiring concentrated inside the cabinet.
The physical format follows the Eurocard profile at 100 × 160 mm, providing predictable clearance for airflow when the module is stacked with adjacent cards. A 32-pin DIN 41612 form D connector carries power rails, oscillator reference signals, and sixteen logic channels to the backplane, allowing quick exchange without soldering. The 24 VDC supply rail feeds onboard converters, and continuous current draw stays below 2 A, so a standard auxiliary supply can support multiple cards in the same crate. Overall power dissipation is limited to less than 50 VA, minimizing heat buildup. Timing for driver pulses is derived from a crystal running near 2.5 kHz, keeping coil energization periods consistent when the ambient temperature changes.
Each logic driver presents a 5 V amplitude and can source up to 30 mA, while separate power stages supply 1.8 A ±20% to solenoids with 5.4 Ω windings. A built-in enable circuit does not activate until the control line exceeds 8.5 V, guarding against unintended starts. Overcurrent conditions open the board’s 2.5 A T fuse, isolating the rack supply. Precision references are maintained by linear regulators that hold ±9 V within ±1%, ensuring stable thresholds for the relay coil, which pulls in at 16.8 V and has a resistance of 2,150 Ω. The assembly weighs 0.15 kg, which reduces the load placed on the rack in multi-axis machines.
