Product Description:

The VT 3002-1-2X-32F is an analog amplifier card manufactured by Bosch Rexroth Indramat for the VT 3000 Analog Amplifiers series. Installed in multi-axis hydraulic controls, the board conditions input commands and regulates valve coil current so that flow and pressure follow setpoints in automated presses, die-casting machines, or test rigs. It is intended for quick replacement inside a 19-inch rack, allowing precise motion to be restored without disturbing adjacent modules.

This card conforms to the Single Euro-Format layout, meaning its PCB width and rear connector position match standard Eurocard sub-racks. A rear connector built to the DIN 41612 pattern routes power, reference signals, and diagnostics through mating back-plane sockets, while a continuous current path of 4 A allows it to drive typical proportional valves directly. For discrete harnesses, the front edge carries a 32-pin, Form F socket that duplicates the back-plane contacts. All supply and control lines tolerate up to 48 VAC/DC, letting the amplifier operate from low-voltage AC transformer loops or stabilized DC rails without changes to the wiring scheme. Screw terminals on the faceplate provide field connections when the board is used outside a rack-mounted environment, and the even-numbered B and Z pin rows simplify signal tracing during installation.

Wiring can be landed with conductors up to 4 mm², so high-integrity grounds or shield drains fit without splitting strands. The heat sink faces forward because the hat rail clips hold the board in a vertical orientation, which helps keep convection airflow unobstructed inside narrow cabinets. Total mass is only 0.5 kg, which eases insertion and avoids overloading light guide rails. Depending on panel layout, the housing can be secured by screws or by the integrated clips for screw or hat rail mounting, which supports stable installation across different machine frames.