VDP15.3GAN.D1-NN-CN

Product Description:

The VDP15.3GAN.D1-NN-CN is part of the VDP IndraControl Panels series from Bosch Rexroth and is built for tight, consistent control in process-heavy systems. The body comes in stainless steel with a surface finish under Ra < 0.8 µm, so it's smooth enough for clean processing, especially in places needing hygiene or corrosion resistance. The Nominal diameter sits at 15 mm, so mid-range flow is what this one's aimed at. The flow coefficient holds at 5.7 m³/h, enough for decent throughput without needing a larger frame.

Pneumatic actuation runs the valve, using control air pressure between 5.5 and 8 bar. That range keeps response times snappy and avoids sluggish control in fast-cycle systems. The valve stays normally closed when not triggered, which works best in setups needing quick shut-off or fail-safe function. It's rated for a maximum operating pressure of 16 bar, enough to handle higher-pressure industrial lines without blowback or seal strain. Inside, the sealing material is FPM (Fluor rubber) — decent chemical resistance and doesn't crack under wide temperature shifts. Used in various industrial sectors, this hardware meets the needs of both automation setups and manual systems needing pressure, motion, or flow regulation.

Speaking of which, the temperature range spans from -10°C to +180°C. That opens the door for hot process media or cold storage piping without swapping out hardware. The connection points are threaded, simple to bolt down without needing flanged setups. Overall, the VDP15.3GAN.D1-NN-CN hits a good middle ground — not oversized, not fragile, and doesn’t overcomplicate the job. It's meant for applications like chemical dosing, clean water lines, or controlled gas flow in automated machinery. No extra sensors, no electric overrides, just a clean pneumatic valve built to run, shut, and repeat.