Product Description:

The VCP35.2ECN-003-PB-NN-PW operator terminal is produced by Bosch Rexroth Indramat within the VCP IndraControl Terminals series. As a human-machine interface, it provides touch-based access to machine parameters, status messages, and diagnostics in automated cells and production lines. The unit integrates with motion controllers and PLCs through built-in Ethernet and fieldbus channels, allowing operators to issue commands and visualize process data directly on the factory floor.

Inside the housing, an embedded RISC ARM9 processor running at 200 MHz executes graphics and communication tasks without an additional PC. The electronics require only 19.2 W of power, a figure that keeps cabinet thermal load low. The supply input is tolerant of plant voltage variation, working from 18 V up to 30 V DC and drawing from a pluggable 24 V feed. One Ethernet TCP/IP port supports peer-to-peer or networked PLC links, while a PROFIBUS DP-Slave interface allows deterministic fieldbus exchange. Two USB host connectors accommodate service sticks or external storage, and the analog-resistive 4-wire touch screen serves as the primary input device. Visual output is rendered at 640 × 480 pixels for consistent VGA clarity.

The visualization is presented on a 10.4-inch TFT panel that shows 256 color shades at VGA resolution. The diagonal of 26.4 cm combines with a 162 mm × 215 mm active area to deliver clear text and graphics. The front face carries an IP65 rating, resisting dust and low-pressure water jets, while the rear is classified IP20 for cabinet installation. A cold-cathode backlight offers a 50,000-hour half-life, and the LCD assembly has a projected service span of 100,000 h. The panel mounts flush into a 222 mm × 303 mm cutout, leaving the 249 mm × 328 mm bezel visible, and its 5 mm depth minimizes enclosure intrusion.