SR-L0.0004.060-14.000 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
5 Minutes
30 Seconds
The Bosch Rexroth Indramat SR-L0.0004.060-14.000 is part of the SR Synchronous Servo Motors series. This motor features a rated speed of 6000 min-1, flange size of 55 mm, and operates with natural convection cooling. It has a brake torque of 1.0 Nm at a brake voltage of 24 VDC and utilizes a resolver feedback type with 8192 increments per revolution.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The SR-L0.0004.060-14.000 is a compact synchronous servo motor produced by Bosch Rexroth Indramat for the SR Synchronous Servo Motors series. It is intended to provide closed-loop velocity and position control in industrial automation axes where limited mass and fast speed changes are required. The motor couples directly to lightweight mechanical stages, converting electrical input from a matched drive into regulated rotary motion for pick-and-place heads, feeders, or small conveyor segments. This layout suits compact axes that need quick reversals and steady positioning over repeated cycles.
The holding system relies on a permanent-magnet brake that engages at 24 VDC and can resist back-driving with 1.0 Nm of static torque, while the coil draws only 0.5 A to reduce standby power. During operation, the frame is cooled by natural convection, so airflow inside the machine cabinet must be managed appropriately. The drive supplies the windings from a DC link stabilized at 670 VDC, allowing the rotor to reach a rated mechanical speed of 6000 rpm without saturation. Torque production scales with current at 0.62 Nm/A, so each additional ampere produces a predictable increase in load torque. Locked-rotor current is 0.65 A, so stalling protection should intervene before excess heating occurs when the shaft cannot turn.
Position feedback is handled by a resolver that gives the controller an interpolated resolution of 8192 increments per revolution, enabling smooth interpolation at high speed. The motor uses a square 55 mm mounting flange that mates with standard IEC motor plates, and the precision-ground shaft measures 9 mm in diameter by 20 mm in length for direct coupling to small pulleys or gearheads. The rotating assembly has a low inertia of 0.09 × 10^-4 kgm², so acceleration ramps remain steep even with added tooling mass. When power is first applied, the drive may see a brief stall torque of 0.4 Nm, and that condition should be coordinated with the current limiter to avoid unnecessary trips during machine homing.
