SR-A2.0026.060-10.000 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
3 Minutes
21 Seconds
The Bosch Rexroth Indramat SR-A2.0026.060-10.000 servo motor is part of the SR Synchronous Servo Motors series and features a flange diameter of 100 mm with a motor length of 208 mm. It has a standstill torque of 2.6 Nm and a rated speed of 6000 rpm. The motor uses a resolver feedback type with 8192 increments per revolution and weighs 6.2 kilograms.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The SR-A2.0026.060-10.000 is a synchronous servo motor produced by Bosch Rexroth Indramat for the SR Synchronous Servo Motors series. Within an automation cell, this motor converts drive controller output into precisely regulated shaft rotation, supplying position and velocity control for pick-and-place units, indexing tables, and other cyclic machinery. Its synchronous design supports accurate response to commanded speed changes and repeatable positioning during continuous start-stop operation.
The unit reaches a rated speed of 6000 rpm, allowing high cycle frequencies when matched with compatible gear ratios. At standstill, it can hold a load with 2.6 Nm of torque while drawing a continuous phase current of 3.4 A, which provides the magnetic flux needed to maintain position without motion. A torque constant of 0.78 Nm/A links drive current to torque production and keeps motor response predictable through the control range. Rotor position is returned to the controller through a resolver that delivers 8192 incr/rev feedback resolution, enabling fine interpolation of angular displacement for tight closed-loop control. The rotor inertia is low enough to support quick acceleration while still helping smooth minor load disturbances during reversing and indexing moves. A 100 mm flange mates to standard IEC machine frames, and the Ø14 × 30 mm shaft passes torque through keyed couplings.
The motor housing measures 208 mm in overall length and weighs 6.2 kg, dimensions that suit compact axes while limiting added mass on moving assemblies. Deep-groove bearings rated for 20 000 h of service support the shaft under radial and axial loads, which helps maintain stable rotation over extended operating periods. Electronic components and mechanical joints tolerate impacts up to 6 g, so brief shocks during transport or machine operation are less likely to disturb internal alignment. An IM B5 mounting form provides a face-mount configuration with the stator aligned by the flange register, helping keep the motor centered on the machine interface.
