Product Description:

The SG-B1.016.060-00.000 is a synchronous servo motor built by Bosch Rexroth Indramat as part of the SG Synchronous Servo Motors series. Intended for high-precision actuation in industrial automation, the unit converts regulated electrical energy from a drive into controlled angular motion for positioning tables, pick-and-place heads, or compact conveyors. An internal two-pole resolver supplies rotor position data in real time, allowing the associated controller to close servo loops with fine resolution. Its smooth shaft supports direct coupling to precision gearheads or belt pulleys for accurate motion transfer.

The motor uses a mounting flange of 70 mm, giving it a standardized footprint for compact automation frames. During continuous operation, the rotor can reach 4800 rpm, a nominal speed that balances dynamic response and thermal limits when driven from a matched inverter. At stall, the machine can deliver 2.55 Nm while drawing 4.8 A of phase current, which supports holding and low-speed indexing duties. The housing has an IP65 rating, so dust is kept out and low-pressure water jets do not affect internal windings. A torque factor of 0.54 Nm/A supports proportional current control, and the smooth Ø11 × 23 mm shaft simplifies coupling alignment.

The rotor bearings tolerate axial thrusts up to 75 N, which helps the motor handle preload on vertical or belt-driven axes. Dynamic response is influenced by a rotor inertia of 0.062×10⁻³ kg·m², allowing quick acceleration when the driven load is kept low. With an overall body length of 166 mm and a mass of 2.6 kg, the motor fits restricted enclosures and adds little moving weight to gantry carriages. Flange accuracy code N supports concentric mounting, and the motor is supplied without a mating connector so the cable set can be chosen separately.