MTS-R01.2 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MTS-R01.2 is a drive module from the RECO Drive Modules series, measuring 192 mm in height and 41.5 mm in width. It features a nominal supply of 24 VDC, supports RS232/RS422/RS485 communication interfaces, and a maximum current draw of 0.5 Amps. The module provides a ground bolt size of M5 and is rated for IP20 protection.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MTS-R01.2 is a communication and expansion module from Bosch Rexroth Indramat in the RECO Drive Modules series. Installed on a RECO rack, it bridges fieldbus traffic and adds control expansion for servo drives, allowing serial links between the higher-level controller and individual power sections. A single module occupies one slot of the rack and acts as an interface hub so that status data, parameter sets, and diagnostic information can be exchanged without additional wiring. It centralizes communication functions that would otherwise require separate interface hardware inside the control assembly.
The module is powered from the control cabinet’s auxiliary bus at 24 VDC, and under normal load it draws no more than 0.5 A. That low current permits dense rack populations without stressing the shared supply. The enclosure has an IP 20 rating, which is appropriate for installation inside enclosed panels with filtered air. Physically, the housing rises to 192 mm while the front width is 41.5 mm, dimensions that match the standard RECO grid so wiring space remains predictable. Its narrow front profile also leaves room for adjacent modules and helps keep terminal access visible in compact cabinets. An M5 ground bolt on the front plate provides a defined bonding point to maintain signal reference and meet safety grounding rules.
The back-plane BT bus uses a D-SUB, 9-pin female connector and supports 4 downstream terminals. The front COM and PROG sockets are both D-SUB, 15-pin female ports and use RS232/RS422/RS485 for serial communication and parameter setting. The I/O bay has a capacity of 16, enabling direct capture of sensor states without added cards. When a larger assembly is needed, the unit slides into the RMB02.2 carrier, and its single-slot footprint helps preserve spacing within the rack. Local I/O handling and serial communication are both contained on the same module, reducing the need for separate interface cards in the rack.
Frequently Asked Questions about MTS-R01.2:
Q: What type of connector does the Bt Bus on the MTS-R01.2 use?
A: The MTS-R01.2 module uses a D-SUB, 9-pin female connector for its Bt Bus interface.
Q: What is the required supply voltage for the MTS-R01.2 module?
A: The nominal supply voltage for the MTS-R01.2 is 24 VDC.
Q: What communication interfaces are supported by the MTS-R01.2?
A: This module provides communication interfaces via RS232, RS422, and RS485 standards.
Q: How many I/O modules can the MTS-R01.2 accommodate?
A: The MTS-R01.2 supports up to 16 I/O module connections within its configuration.
Q: What is the protection category of the MTS-R01.2 module?
A: The protection category of the MTS-R01.2 is rated at IP 20.
