Product Description:

The MSK101E-0200-NN-M1-BP2-NNNN is a servo motor produced by Bosch Rexroth Indramat and belongs to the MSK IndraDyn S Synchronous Motors series. Within automated machinery, this motor converts regulated electrical energy into precise rotary motion for positioning tasks such as gantry axes, packaging spindles, and material-handling drives. Its integrated holding brake lets the axis stay fixed when power is removed, and the sealed housing allows direct mounting on process equipment without an additional enclosure.

Heat is dissipated through natural convection, so airflow around the housing is essential during continuous duty. The electrically released holding brake supplies 70 Nm of static torque to secure vertically loaded shafts during standby. A protection rating of IP65 seals the interior against dust ingress and low-pressure water jets, which helps the motor operate in humid plant areas. The permitted ambient operating range is 0–40 °C, matching typical factory conditions. Position feedback comes from an optical encoder that delivers 128 signal periods per revolution, allowing the drive to resolve fine angular increments for smooth velocity control. Mechanical form factors are set by motor size 101 and length E, while a B-side power connector simplifies cable routing in cabinets located to the right of the axis.

The feedback hardware uses the Hiperface interface, letting the servo drive read absolute rotor position immediately after power-up. The encoder is multi-turn absolute, so the control system retains turn count without a homing move, and its optical scanning principle helps reduce electrical noise. Torque is transmitted through a shaft with keyway, which provides a secure mechanical connection to the driven load. The motor uses insulation class 155, allowing winding temperatures up to 155 °C during brief overloads. Winding code 0200 indicates the electrical configuration matched to compatible IndraDrive controllers for nominal current operation.