Product Description:

The MSK101D-0200-FN-S1-AP0-NVNN synchronous servomotor is produced by Bosch Rexroth Indramat within the MSK IndraDyn S Synchronous Motors series. Designed for closed-loop industrial automation, the motor converts drive output into precisely regulated torque and speed for positioning, packaging, and material-handling axes. Its compact 101-frame construction supports direct coupling to machinery, and integrated feedback allows a compatible drive to monitor rotor position during acceleration, indexing, and speed-controlled motion. This layout suits machine sections where accurate starts, stops, and speed changes must be repeated throughout continuous production.

Thermal management relies on liquid cooling, so coolant passing through the stator jacket removes heat and helps the motor maintain rated torque without external airflow. Position feedback uses the Hiperface serial interface, and high-resolution signals are derived from a scale with 128 signal periods. The scanning principle is optical, which supports accurate interpolation, and the measuring system is single-turn, so the motor reports absolute position within one mechanical revolution. Mechanical configuration follows length code D in the 101 frame, while winding code 0200 matches the electrical characteristics to compatible IndraDrive power stages. The motor is supplied without a holding brake, so any static load must be held by the drive or external mechanics. Power and feedback connectors are oriented on the A-side, which can simplify cable routing in enclosed machine layouts.

The sealed housing carries an IP65 protection rating, keeping dust and low-pressure water jets away from internal components during industrial use. Continuous operation is specified for an ambient range of 0 to 40 °C, and output may need to be reduced outside that range. Torque is transmitted through a shaft with keyway, allowing standard hubs and couplings to lock securely under cyclic loads. Class 155 insulation sets the maximum permissible winding temperature and reflects the winding material system used for repeated dynamic duty. The enclosed housing is also suitable for installations near conveyors and process equipment where airborne debris or routine cleaning may be present.