Product Description:

The MSK101C-0450-NN-M2-AP0-RNNN is an IndraDyn S synchronous servomotor manufactured by Bosch Rexroth Indramat for the MSK IndraDyn S Synchronous Motors series. It is intended for direct connection to planetary gearboxes, ball-screw drives, and belt stages in closed-loop motion systems. This arrangement supports repeatable torque and velocity control where fast axis movement is required on automated lines and gantry systems.

The motor uses natural convection for heat dissipation, so airflow around the housing must remain unobstructed during operation. A rotor machined for increased concentricity minimizes radial runout and supports smooth coupling during continuous rotation. Digital feedback is transferred through the EnDat2.1 interface, and its optical sensor generates 2048 signal periods per revolution for high-resolution interpolation inside the drive controller. The housing carries an IP65 rating that blocks dust and low-pressure water jets, and the output end uses a shaft with keyway for standardized torque transfer. Frame size 101 and length code C set the mounting footprint, while the power connector is located on the A-side for simplified cabinet wiring. The motor is supplied without a holding brake, so any static load must be secured by external means.

The encoder has multi-turn absolute feedback, so the drive retains position data across power loss and can resume operation without a homing cycle after an emergency stop. Continuous service is supported between 0–40 °C, which matches typical machine-room conditions. The winding insulation system is rated to class 155, allowing elevated internal temperatures without accelerated degradation of the insulation materials. Winding code 0450 identifies the conductor cross-section and turn count used for the electrical parameters expected by MSK drive modules.