Product Description:

The MSK101C-0450-NN-M1-AG0-NNNN is produced by Bosch Rexroth Indramat and belongs to the MSK IndraDyn S Synchronous Motors series. It is an IndraDyn S synchronous servomotor for automated axes, material-handling modules, and packaging stations where tight position and velocity control are required. By pairing permanent-magnet technology with an optical feedback device, the unit supports closed-loop motion control in industrial automation. It is intended for applications that require repeatable motion over continuous production cycles.

A protection rating of IP65 seals the housing against dust ingress and low-pressure water jets, enabling installation outside control cabinets. Heat is removed through natural convection, so unobstructed airflow around the frame is necessary instead of forced cooling. For position feedback, the motor uses a Hiperface interface, and this serial protocol transfers absolute position and electronic nameplate data to compatible drive amplifiers. The optical scanner resolves 128 signal periods per mechanical revolution, and its memory uses a multiturn absolute format so the controller can retain turn information after power is removed. This feedback arrangement supports startup without a reference run when the connected control system is configured for absolute encoder operation.

The motor has size 101 and length code C, which indicate the frame and active stack height used for torque selection. The power connector is located on the A-side to keep cabling on one face of the machine and simplify routing in compact assemblies. Operation is permitted in an ambient range of 0 to 40 °C, and a plain shaft allows direct coupling to precision gearboxes or timing pulleys. The windings use insulation class 155, and winding code 0450 identifies the electrical configuration of this motor, which is supplied without a holding brake. The standard mechanical design follows the common MSK layout used for servo-axis installations.