Product Description:

The MSK100D-0350-NN-S1-AP0-NNNN is a synchronous servo motor produced by Bosch Rexroth Indramat for the MSK IndraDyn S Synchronous Motors series. This servo motor accepts regulated three-phase power from compatible Rexroth drive controllers and converts it into precise angular motion for positioning tasks, feed drives, and coordinated axes in industrial automation. It serves as the electromechanical actuator in equipment such as pick-and-place stations, printing presses, and material-handling modules where consistent velocity control and repeatable positioning are required throughout repeated duty cycles.

Thermal management relies on natural convection, so no external fan or liquid circuit is required, and heat dissipates through the housing during operation. The frame size is 100 with length code D, giving a stator stack suited to medium-torque tasks while still fitting common mounting patterns. The motor is sealed to IP65, which helps block dust and low-pressure water jets from internal components. For feedback, the unit uses a Hiperface optical encoder that provides 128 signal periods in a single-turn format, allowing the drive to resolve rotor position accurately from standstill. Operation is intended for ambient temperatures from 0 to 40 °C, and power arrives through an A-side connector that simplifies cable routing. A holding brake is absent, so load retention must be handled by the drive or by external locking hardware when the axis is stopped.

The motor uses a shaft with a keyway, which engages couplings directly and helps prevent slip under cyclic torque. Class 155 insulation allows the windings to tolerate elevated copper temperatures associated with dynamic duty cycles without premature degradation. Winding code 0350 sets the resistance and inductance values used with compatible IndraDrive amplifiers, helping the drive supply the expected current envelope. The motor is suited to feed axes and transfer systems that rely on controlled acceleration and repeatable stopping points.