Product Description:

The MSK100D-0350-NN-M1-AG0-NNNN servo motor is built by Bosch Rexroth Indramat and belongs to the MSK IndraDyn S Synchronous Motors series. As a brushless AC motor, it converts controlled electrical input from an IndraDrive into precise mechanical rotation for positioning duties in automated packaging lines, gantry axes, and similar motion modules. Tight coupling between its feedback device and the drive allows closed-loop speed and torque regulation required for repeatable industrial processes. This operating profile is well suited to synchronized machine movements that require accurate response during frequent starts, stops, and speed changes.

Thermal dissipation relies on natural convection, meaning heat is shed through the housing without external fans or liquids, so mounting space must permit free airflow. Rotor position is reported through a Hiperface interface that carries power and digital data on the same connector, which helps simplify cabling to the drive controller. Inside the encoder, an optical scanning head divides one mechanical revolution into 128 signal periods, providing fine interpolation for smooth low-speed motion. The stator and lamination stack correspond to size 100, giving the motor a large magnetic cross-section that supports higher continuous torque than smaller MSK frames.

The feedback device provides multi-turn absolute position data, so the controller retains position information after power loss without a homing routine. Because the unit is supplied without a holding brake, load holding must be provided by the drive’s torque or an external clamp when power is removed. The construction uses length D, which adds extra stator iron for higher torque density while keeping the 100-frame footprint. An A-side power connector directs the three-phase leads toward one end of the machine, allowing consistent cable routing with other MSK motors on the same mounting rail.