Product Description:

The MSK100C-0200-NN-S2-LP0-RNNN is a synchronous servomotor produced by Bosch Rexroth Indramat for the MSK IndraDyn S Synchronous Motors series. It serves as an electromechanical actuator that converts drive commands into accurate torque and speed, allowing automated machinery to position loads with tight velocity and repeatability requirements. This motor is intended for servo axes that need consistent motion control during repeated positioning and speed-regulated operation.

The motor eliminates external fans by using natural convection for heat dissipation, and its housing meets the IP65 protection class to block dust and water jets during operation. An increased concentricity design reduces shaft runout and helps support smoother coupling alignment. Frame size 100 with length code C gives the stator stack dimensions, while winding code 0200 indicates the coil impedance and torque constant. The insulation system uses thermal class 155 for continuous winding temperatures up to 155 °C. A left-side power connector helps route cables along machine guards. Position feedback is delivered through the EnDat2.1 interface, and the integrated encoder provides 2048 signal periods per revolution. The encoder uses optical scanning, which helps maintain resolution without magnetic influence.

The feedback device uses a single-turn configuration, supplying absolute position within one revolution and avoiding multi-turn gear wear. Mechanical output is provided by a shaft with a keyway, which supports positive torque transfer into pulleys or rigid couplings. The unit is supplied without a holding brake, so static load security must be provided by drive torque or an external clamp. Continuous service is specified for ambient conditions from 0 to 40 °C, which matches the natural cooling path and the class 155 insulation margin. This combination suits sealed servo axes that require precise feedback and simple thermal management.