Product Description:

The MSK100C-0200-NN-M1-RP2-NNNN synchronous servomotor is produced by Bosch Rexroth Indramat within the MSK IndraDyn S Synchronous Motors series. It delivers closed-loop rotary motion for positioning axes, pick-and-place heads, and other CNC or packaging machinery that depend on precise speed and torque control. By integrating feedback electronics and a matched winding set, the unit converts drive controller output into mechanical power with tight tracking accuracy and low settling time. This layout supports smooth starts, controlled acceleration, and accurate stopping during repetitive machine cycles.

Heat removal from the stator and winding is handled by natural convection, so installation must allow unobstructed airflow around the housing rather than external cooling devices. Position feedback travels over a Hiperface interface, and a high-precision optical disk inside the encoder delivers 128 signal periods for fine incremental data used in servo loop interpolation. The encoder stores absolute position across power cycles. Combined with an electrically released brake rated at 70 Nm, the motor can hold the shaft when the machine is idle and return to its stored position after restart. Mechanical geometry follows motor length C, which provides a longer active section within this motor platform.

The optical encoder operates in multi-turn absolute mode, counting complete shaft revolutions so the controller keeps position data even after manual movement. A keyed shaft provides positive mechanical coupling, while frame size 100 standardizes flange and pilot dimensions for common gearbox and coupling arrangements. Power enters through a right-side connector, which can simplify cable routing when the drive is mounted above the motor. The motor uses winding code 0200, which corresponds to the electrical characteristics expected by a matching drive controller.