Product Description:

The MSK075C-0200-NN-M1-UG0-NNNN is a synchronous servomotor produced by Bosch Rexroth Indramat in the MSK IndraDyn S Synchronous Motors series. As a compact rotary actuator, it delivers precise torque and position control for factory automation axes, material-handling gantries, and pick-and-place modules. Its stator and rotor geometry suit medium-inertia loads commonly found in conveyor and packaging machinery. The motor also connects directly to IndraDrive controllers through a single hybrid power-feedback cable, which helps keep wiring compact and reduces the number of separate connections around the axis. In automated equipment, this supports indexing, transfer, and placement tasks that depend on smooth acceleration, repeatable stopping, and stable motion over long production runs.

The housing carries a protection rating of IP65, which seals the stator against dust and low-pressure water jets that may be present inside machine frames. Heat generated by the windings is removed through natural convection, so no external blower or liquid circuit is required. Position data are exchanged over a Hiperface serial link, and the embedded optical encoder provides 128 signal periods per mechanical revolution for accurate motion feedback. It also uses a multiturn absolute track so position information is retained through power cycles without a homing sequence in many applications. The serial feedback stream gives the drive continuous rotor information for commutation, speed regulation, and accurate position tracking during rapid cycle changes.

The motor has a plain shaft, which supports backlash-free clamp couplings and avoids the wear associated with keyed connections. It is supplied without a holding brake, so any load-retention function during power-off conditions must be handled by external means. Continuous duty is permitted in ambient air from 0 to 40 °C, and Class 155 insulation helps the stator winding withstand normal thermal loading. A rotatable 240° encoder connector allows flexible cable routing in tight machine spaces, and this arrangement is useful when the motor is installed near guards, conveyor frames, or tooling plates with limited clearance. The standard design uses frame size 075, length code C, and winding code 0200.