MS2N10-D0BNN-CSVL0-NNNNN-NN

Product Description:

The MS2N10-D0BNN-CSVL0-NNNNN-NN servo motor is produced by Bosch Rexroth Indramat for use in the MS2N Synchronous Servo Motors series. This model’s housing takes a flange size F form, giving a firm mounting in setups where reliability and precise orientation are both needed. The motor uses natural convection (uncooled) as its main cooling setup, so no extra fans or liquid parts are part of the housing and that keeps the design simple. For motion, the rated speed goes up to 3000 rpm, letting the motor join a variety of automated lines—timing and cycle rates don’t get limited here. Torque output is established at up to 25 Nm, though checking the individual datasheet is always best for the exact subvariant within this range.

This servo motor comes with IP65 protection, meaning that jets of water, oils, and airborne dust mean little for long-term installation work. A plug connector—rotatable by design—is used for connection, allowing the lead-out to take the most open route and fit inside control cabinets without tight bends. For communication and feedback, a single cable setup runs both encoder data and general signal or power in one line, keeping wiring annoyances low especially when panels are crowded. The integrated encoder is absolute type, which gives feedback about motor shaft location in all cycles, including power loss or emergency stop situations (models use Hiperface DSL or others depending on suffix chosen).

Applications needing high reliability at medium to high speeds, or constant smooth torque, pick out this motor thanks in part to the MS2N platform’s feedback system and flexible mounting. Materials and surface finishes match industrial expectations for wear, environments with vibration, and daily washdown cycles. Where precise positioning and quick recovery are part of the job (pick-and-place arms, linear transfer, or even order sorting stations), the MS2N10-D0BNN-CSVL0-NNNNN-NN keeps consistent output.