MS2N06-D1BNN-CMSH2-NNNNN-GE160N2020BN-NN

Product Description:

MS2N06-D1BNN-CMSH2-NNNNN-GE160N2020BN-NN is a high-speed synchronous motor. It requires AC input from a connected motor controller. A type plate on the housing lists several pieces of information needed for motor identification. These include the type code, serial number, date of manufacture, and critical technical specifications. The product documentation lists safety precautions needed for safety of personnel and equipment. To prevent burns, operators must ensure the motor has cooled down before working on it or near it. It can take up to 140 minutes for the motor to cool down after its power is disconnected. Electrical connections must be made by trained staff following proper installation and safety procedures. The shaft must be protected from damaging strikes. Furthermore, the specified limits for axial and radial loads must not be exceeded.

MS2N06-D1BNN-CMSH2-NNNNN-GE160N2020BN-NN is a 3-phase motor. Premium permanent magnets are used in its construction. It can operate at up to 40 degrees Celsius without output derating. The smooth shaft on the motor is without a seal. Therefore, the protection rating of the motor is IP64. A shaft seal can improve the rating to IP65 and sealing air can improve it to IP67. MS2N06-D1BNN-CMSH2-NNNNN-GE160N2020BN-NN is self-cooled motor. The benefit of this cooling method is that additional exterior power is not required for a cooling fan. At 60K overtemperature, the motor produces 5.05 Amps standstill current and 9 Nm standstill torque. Ratings for motor speed, torque and power are 3000 RPM, 6.4 Nm and 2.01 kilowatts. Bosch has designed the motor with one cable connection. An M23 connector on the motor is the point of termination for the cable that carries power, feedback, and control signals for the brake. Feedback is provided by an advanced performance ACUROlink multiturn encoder with 20 bit resolution. The motor is equipped with a size 2 holding brake.