MS2N06-D0BRN-CSSG0-NNNNN-NN

Product Description:

The MS2N06-D0BRN-CSSG0-NNNNN-NN comes from Bosch Rexroth’s MS2N Synchronous Servo Motors line and runs without a brake installed — model code confirms NNNNN. That setup works best for systems not needing stop-hold when power cuts out. Cooling’s handled by self-cooling design, so no fans, no extra airflow routing. The Encoder inside is a Single Turn, Absolute type, which means the system gets position right after power-up. No drift, no recalibration headaches. Speed holds steady at 3000 rpm rated, and there’s room up to 6000 rpm on the top end, depending on drive config.

Stall torque is 3.8 Nm, solid for smaller machines pushing a constant load or dealing with moderate resistance at standstill. IP65 protection keeps the internals safe from dust and splashes — useful in midline automation where coolants or debris fly. Rated power is 0.95 kW, enough for active axes, feeders, or spindles that don’t need high horsepower but still need precision. Rated current sits at 2.4 A, keeping it in check with standard inverter settings. A Straight connector output saves space along walls or machine casings. Shaft orientation stays simple, and no weird angles to deal with during mounting.

Frame size is 06. Voltage is 400 V — typical for Bosch drives, no mismatched specs when pairing. Used often in automated packaging, light press systems, or repetitive material pickers. Synchronous motor type, so torque doesn’t fall off a cliff at low speed like some AC units. It just keeps turning evenly. No fluff built into this unit — nothing modular or programmable onboard. It’s wired to go and that’s the end of it. Good fit where form factor matters but demands stay clean and repetitive. Slots into most cabinets, and being self-contained, won’t add thermal mess to the system. Just install, wire, run.