MS2N03-D0BYN-CSSK1-NNANN-NN
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911383144
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The MS2N03-D0BYN-CSSK1-NNANN-NN Servo Motor is manufactured by Bosch Rexroth Indramat. This motor has a winding of 9,000 min with a Single-turn encoder design. This motor is Equipped with a holding brake, it has a Keyway, with shaft seal shaft, and a M23 Single-Cable connection, turnable electrical connection.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The Bosch Rexroth MS2N03-D0BYN-CSSK1-NNANN-NN synchronous servomotor has a sound pressure level of less than 75 dBA. This motor supports IM B5, IM V1, and IM V3 installation according to EN 60034-7 specifications. The product houses deep-groove ball bearings with permanent grease lubrication. This device has reduced heat dissipation when its surface is soiled. The unit must be run without load at 800 rpm to 1000 rpm for an hour after storage if the life of the bearings exceeds 12 months. It encounters axial and radial forces when it is operated. This motor supports the rotation of its electrical connector.
The product features a voltage rating of 24 V +/-10% for its holding brake. This device is meant to be operated within the ambient conditions specified by the manufacturer. The unit should not be worked on when its surface is hot as this can cause burns. Its damaged connection cables must be replaced immediately. This motor encompasses a shaft sealing around the output shaft. The product should be stored with its protective covers intact. This device depicts a running noise if its bearing is damaged or there are foreign bodies inside its housing. The unit has an IP 65 protection rating as per EN 60034-5 specifications. Its holding brake works on the electrically releasing principle.
This motor tends to encounter damage of its winding and temperature sensors because of improper use. The product installation must be carried out in the de-energized state. This device features a cooling time of up to 140 minutes. The unit is coated with a standard RAL 9005 black varnish on its housing. Its mounting flange is designed as per DIN 42948 specifications. This synchronous servomotor features the drive end on Side A and non-drive end on Side B.
