Product Description:

The MS2E10-D0BNN-CSVK2-NNNNN-NN is a three-phase permanent-magnet synchronous servomotor from Bosch Rexroth Indramat in the MS2E Synchronous Servomotors series. It drives closed-loop axes in industrial automation by converting electrical commands into accurate rotary motion for packaging equipment, pick-and-place gantries, and other motion-control stations. Its integrated feedback interface simplifies setup and enables deterministic communication with Rexroth drive controllers.

At a nominal speed of 3000 rpm, the rotor sustains full velocity without derating, while the size 2 brake delivers a holding torque of 53.00 Nm that secures vertical or suspended loads when power is removed. Position data comes from the ACUROlink single-turn encoder, which provides a 20-bit resolution for precise interpolation in multi-axis motion profiles. The enclosure has an IP65 rating with a shaft sealing ring, which prevents dust and water jets from entering the stator and permits installation outside climate-controlled cabinets. A PT1000 sensor embedded in the windings supplies the drive with temperature feedback. Deep-groove ball bearings handle radial forces with low maintenance requirements.

Thermal management relies on the motor’s self-cooling design, allowing continuous operation within an ambient temperature range of 0 to 40 °C without external airflow. Mechanical alignment is simplified by a centering collar diameter of 180 mm and a flange size of 196 mm, both of which match the B5 / IM3001 mounting pattern. The 14 mm holes are arranged on a 215 mm pitch circle to accommodate standard fasteners. A keyway shaft with a sealing ring transmits torque while maintaining protection against internal contamination. Compliance with ATEX standards permits use in atmospheres that may contain explosive gases. Performance remains unchanged at installation elevations up to 1,000 m above mean sea level.