MMD042A-030-EG0-KN Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911281523
The Bosch Rexroth Indramat MMD042A-030-EG0-KN is a synchronous motor from the MMD Synchronous Motors series, featuring a flange size of 70 mm and a centering diameter of 50 mm. It delivers a continuous torque at standstill of 1.3 Nm and a maximum theoretical speed of 5000 min-1. The motor weighs 1.6 kg, uses an incremental encoder with a resolution of 2,500 increments, and is rated at IP65 protection class.
Internal Product Review
The MMD042A-030-EG0-KN is a Bosch Rexroth Indramat synchronous motor with IP65 protection. An incremental encoder with 2,500-increment resolution supports consistent feedback and accurate motion control. A 1.3 Nm continuous standstill torque rating and 5000 min-1 maximum theoretical speed make the motor an efficient choice for responsive servo duty.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MMD042A-030-EG0-KN is a synchronous motor manufactured by Bosch Rexroth Indramat within the MMD Synchronous Motors series. It is designed as a compact servo actuator for small handling modules, pick-and-place axes, and other automated stations that need repeatable rotary motion. The motor uses an incremental encoder to send real-time position data to the drive controller, supporting closed-loop speed and position control during normal operation. This layout suits compact automation equipment where accurate starts, stops, and repeated cycles are required throughout routine machine operation. It is supplied without a holding brake, so any static load must be secured by external means or by maintained drive torque.
Its continuous torque at standstill is 1.3 Nm, allowing the shaft to deliver steady force for prolonged positioning tasks without exceeding thermal limits. Under rated excitation, the rotor reaches a nominal speed of 3000 rpm, and it can operate up to 5000 rpm for short periods when higher axis speed is required. The housing has an IP65 rating, which helps keep dust and low-pressure water jets away from internal components in typical machine environments. A centering diameter of 50 mm aligns the motor flange with gearboxes or brackets and helps maintain accurate mounting. Torque and thermal behavior follow winding code 030, which aligns the motor with compatible drive parameters.
The motor has a flange side length of 70 mm, a plain shaft that is 14 mm in diameter, and a shaft seal that helps limit lubricant migration and the entry of contaminants. Peak acceleration is supported by a maximum theoretical torque of 3.36 Nm, giving the axis additional headroom for rapid indexing and short dynamic moves. The incremental encoder provides 2,500 increments per revolution for fine feedback resolution, and the motor has a mass of 1.6 kg, which suits compact mechanical assemblies. Motor length A and a plug connector that exits toward the A-side on a 25 cm lead help simplify cable routing where installation space is limited, and the shaft seal also helps protect the internal bearings from spray and dust.
