MHP115C-024-HG1-ANNNNN Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911291688
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
3 Minutes
52 Seconds
The Bosch Rexroth Indramat MHP115C-024-HG1-ANNNNN is part of the MHP Synchronous Motors series and features a continuous standstill torque of 70.0 Nm with natural convection housing. It comes with a plain shaft with sealing ring, an incremental encoder providing 2048 increments of feedback, and an IP65 protection category. The motor includes a holding brake with a holding brake torque of 70.0 Nm and supports allowed ambient temperatures from 0 to 40°C.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MHP115C-024-HG1-ANNNNN is a synchronous servo motor manufactured by Bosch Rexroth Indramat and included in the MHP Synchronous Motors series. This motor is intended for industrial automation tasks where closed-loop speed and position control are required. By pairing with an Indramat drive controller, it supplies regulated torque to indexing tables, packaging modules, and material-handling axes. Its synchronous design allows the drive to maintain accurate rotor alignment during repeated starts, stops, and speed changes in cyclic motion.
Thermal management relies on natural convection, so heat is dissipated through the aluminum frame without forced airflow. Under these conditions, the motor can sustain 70.0 Nm of continuous torque at standstill, allowing static load control while the windings remain within limits. The housing is rated to IP65, preventing dust ingress and protecting against low-pressure water jets during washdown service. Operation is specified between 0 to +40 °C, matching typical enclosure climates found on factory floors. The winding insulation is class F, permitting internal temperatures up to 155 °C before dielectric degradation.
Electrical characteristics follow winding code 024, which sets the resistance and inductance values expected by compatible MHD and HDS drives. Rotor position is reported by an incremental encoder with 2048 increments, enabling precise velocity loops and consistent position feedback. Power leads exit through a connector on side A, simplifying cable routing when the unit is installed in line with gearboxes. The motor has frame size 115 and length C, which helps balance mass and dynamic response. A plain shaft with a sealing ring mates directly to couplings, and the integrated holding brake secures vertical loads when power is removed. This arrangement supports compact installation on servo-driven machine axes.
Frequently Asked Questions about MHP115C-024-HG1-ANNNNN:
Q: What is the continuous standstill torque of the MHP115C-024-HG1-ANNNNN motor?
A: This model provides a continuous torque at standstill of 70.0 Nm when using natural convection.
Q: What type of drive shaft does the MHP115C-024-HG1-ANNNNN motor have?
A: The MHP115C-024-HG1-ANNNNN uses a plain shaft with a sealing ring.
Q: What kind of motor feedback is provided by the MHP115C-024-HG1-ANNNNN?
A: An incremental encoder with 2048 increments is included for motor feedback on this model.
Q: Does the MHP115C-024-HG1-ANNNNN motor have a holding brake?
A: This model is equipped with a holding brake that provides 70 Nm of holding torque.
Q: What is the protection category of the MHP115C-024-HG1-ANNNNN motor?
A: The protection rating for this motor is IP65, offering dust tightness and protection against water jets.
